What should be paid attention to during the use of analytical inductors?
Release time:
2023-09-20
1, pay attention to the wire (enameled wire, yarn package or bare wire), commonly used enameled wire. Find the right thread.
2. Inductance use occasions
Humidity and dryness, the level of ambient temperature, high frequency or low frequency environment, to make the inductance performance is inductive, or impedance characteristics, should pay attention.
3. Frequency characteristics of inductance
At low frequencies, the inductor generally exhibits inductive characteristics, which only stores energy and filters high frequency. But at high frequencies, its impedance characteristics are very obvious. There are energy-consuming fever, perceptual effect to reduce the phenomenon. The high frequency characteristics of different inductors are different.
4, the inductor design to withstand the maximum current, and the corresponding heating situation.
5. When using the magnetic ring, compare the magnetic ring part above to find out the corresponding L value and the use range of the corresponding material.
Previous Page
Latest information
What is the main role of the filter in the power line
As the name suggests, it is a device for filtering waves. "Wave" is a very broad physical concept. In the field of electronic technology, "wave" is narrowly limited to the process of describing the fluctuation of various physical quantities over time. This process is converted into a time function of voltage or current through the action of various sensors, which is called a time waveform of various physical quantities, or a signal.
2023-09-20
Transformer short circuit fault reason
There are many reasons for transformer internal faults and events caused by short circuit at transformer outlet, which are related to structural planning, quality of raw materials, technological level, operating conditions and other factors, but the selection of electromagnetic wire is the key. From the analysis of the transformer in recent years, it can be seen that there are roughly the following reasons for the electromagnetic wire.
2023-09-20
Coil inductance value considerations
The inductance value in the total loop with different connection modes is different. When the four coils are connected in parallel, the inductance value is the smallest and the current in the loop is the largest; when the four coils are in reverse series, the inductance of the loop is the largest and the current of the loop is the smallest. No matter from the analysis of the current flowing through each coil or the energy distributed from the coil, the connection mode of four coils is the most appropriate.
2023-09-20
Contact Us
Shandong Weihai Tse Electronic Technology Co,Ltd
Telephone: +86-0631-5964403
Mobile: +86-18669341544(Manager Wu)
Email: ohhsh0218@163.com
Email: Mike3539898@Gmail.com
Address: No.7 Wutong Road, Weihai Economic and Technological Development Zone
Enterprise WeChat customer service
Shake audio and video number
Copyright 2023©Shandong Weihai Tse Electronic Technology Co,Ltd. All Rights Reserved